1 Vásárlói vélemény magyar nyelven: colorFabb stoneFill Light Gray

A very interesting stone filament

5 csillaggal4értékelt.

It's probably the most interesting filament I've worked with so far. Instead of containing stone powder it seems to mimic a rough texture with slight expansion and some fibery composition like it was made of some kind of cellulose. The final texture is very satisfying.

The prints feel like they are made of paper, even though the material seems to be just fine around water (I made planters from it).
There is a slight expansion, flow rate needs to go down a bit (77% for me). With too much cooling there can be lots of stringing so keep temp on the lower side with only as much fan as needed. I could get both walls and fill surfaces to be very fine after some adjustments of print setting, final prints look good with a little touchup afterwards.

A serious downside is that the filament surface is insanely rough and the filament is hard to flex, I had real trouble even feeding it through a 1.9mm ID PTFE tube to my direct extruder. With 2mm inner diameter it's probably slightly better, even though I wouldn't even think about trying to print it with a bowden extruder. So only 4 stars goes for leaving this crucial info out on the product page, which can be a dealbraker for many.

Ez az értékelés hasznos volt az Ön számára? igen (1) nem (0)